Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 1996 Mercedes-Benz E320, 1996 Mercedes-Benz E300, 1995 Mercedes-Benz E420, 1995 Mercedes-Benz E320, and 1995 Mercedes-Benz E300. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||
|---|---|---|---|---|
| Brakeline Union Bolt | 11 (15) | |||
| Brake Pressure Switch-To-Master Cylinder | 11-22 (15-30) | |||
| Caliper Mounting Bolt (1) | ||||
| Front | 85 (115) | |||
| Rear | 37 (50) | |||
| Hydraulic Unit Brakeline Fitting | 10 (14) | |||
| Wheel Lug Bolt | ||||
| E320 & E420 | 81 (110) | |||
| Wheel Speed Sensor Bolt (Front) (1) | 16 (22) | |||
| INCH Lbs. (N.m)Β | ||||
| Bleed Screw On Caliper | 44 (5) | |||
| Brake Disc-To-Hub Or Flange | 89 (10) | |||
| Wheel Speed Sensor Bolt (Rear) (1) | 72 (8) | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
