2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE

Logic Section

WARNING: This page is about a different car, the 1996 Mercedes-Benz E320, 1996 Mercedes-Benz E300, 1995 Mercedes-Benz E420, 1995 Mercedes-Benz E320, and 1995 Mercedes-Benz E300. However, it is still accessible from the selected car via links, so may be relevant.

This section employs wheel slip, wheel speed accel-eration and deceleration signals for each controlled front wheel or rear wheels. Output signals of logic section control hydraulic unit solenoid valves.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.