2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE

Section 9 (Anti-Lock/Traction Control): Description

WARNING: This page is about a different car, the 1996 Mercedes-Benz E320, 1996 Mercedes-Benz E300, 1995 Mercedes-Benz E420, 1995 Mercedes-Benz E320, and 1995 Mercedes-Benz E300. However, it is still accessible from the selected car via links, so may be relevant.

The Bosch-designed Anti-Lock Brake System (ABS) uses a hydraulic unit with 3 fast-switching solenoid valves, 3 speed sensors, an electronic control unit with overvoltage protection and a wire harness with relays. A Yellow ABS warning light comes on as ignition is turned on and goes out when engine is running. The ABS system is programmed to activate after 7.5 MPH.

When vehicle speed is more than 3 MPH, Built-In Test Equipment (BITE) checks ABS. If any fault is found, ABS warning light comes on again. When warning light goes on, ABS is switched off and conventional brake system takes over.

If battery voltage is less than 11 volts, when ignition is turned on and test speed exceeded, ABS remains off until alternator increases voltage to more than 11 volts. Warning light will then go out. After repairing ABS system, perform a light test to check system. Ensure light goes out after 7 MPH.

NOTE: The entire ABS system must be checked if repair includes any ABS component or if units are replaced following an accident.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.