Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE
Left Cylinder Bank CMP Sensor (B6/2)
NOTE:
Left cylinder bank Camshaft Position (CMP) sensor (B6/2) is located at top front of engine between left and right adjustable camshaft timing solenoids. Adjustable camshaft timing solenoids are located at front of cylinder head. Right Camshaft Position (CMP) sensor (B6/3) and left CMP sensor (B6/2) are located next to each other. The left CMP sensor (B6/2) is positioned nearest to passenger fender. For ME-SFI control module location and identification, see ME-SFI CONTROL MODULE CONNECTOR IDENTIFICATION
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.