Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE
Right Cylinder Bank ME-SFI Control Module (N3/12)
NOTE:
Manufacturer identifies both left and right pedal value sensors as (B37). Right cylinder bank pedal value sensor is located in right cylinder bank throttle valve actuator (M16/4). Right cylinder bank throttle valve actuator is located on left side of engine (because of intake manifold crossover). For ME-SFI control module location and identification, see ME-SFI CONTROL MODULE CONNECTOR IDENTIFICATIONΒ
.
- Pedal Value Sensor (B37), Signal 1 -Β Connect DVOM between right cylinder bank ME-SFI control module (N3/12) connector 1 terminals No. 18 and 19 (socket box terminals No. 18 and 19). Turn ignition on. With throttle closed, voltage should be 0.2-0.5 volts. With throttle at Wide Open Throttle (WOT), voltage should be 4.3-4.8 volts. If voltage is within specification, go to next step. If voltage is not within specification, possible causes are wiring harness failure, voltage supply problem to pedal value sensor (B37), voltage supply problem to pedal value sensor (B37) or pedal value sensor (B37) defective. Repair as necessary. To check voltage supply to pedal value sensor, go to next step.
- Pedal Value Sensor (B37), Signal 1 Voltage Supply -Β Connect DVOM between right cylinder bank ME-SFI control module (N3/12) connector 1 terminals No. 18 and 17 (socket box terminals No. 18 and 17). Turn ignition on. Voltage should be 4.75-5.25 volts. If voltage is okay, go to next step. If voltage is not okay, possible cause is right cylinder bank ME-SFI control module (N3/12) defective. Repair as necessary.
- Closed Throttle Signal 1 -Β Connect DVOM between right cylinder bank ME-SFI control module (N3/12) connector 1 terminals No. 38 and 16 (socket box terminals No. 38 and 16). Turn ignition on. With throttle closed, voltage should be more than 4 volts. With throttle at Wide Open Throttle (WOT), voltage should be 2-3 volts. If voltage is within specification, test is complete. If voltage is not within specification, possible causes are wiring harness failure or right cylinder bank ME-SFI control module (N3/12) defective. Repair as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
