2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE

Testing Procedure

NOTE: For ME-SFI control module location and identification, see ME-SFI CONTROL MODULE CONNECTOR IDENTIFICATION  .
  1. Actuation -  Connect DVOM between right cylinder bank ME-SFI control module connector 1 terminals No. 12 and No. 25 (socket box terminals No. 12 and 25). Start engine and idle. Allow engine to idle for at least 2 minutes after engine coolant temperature reaches more than 176°F (80°C). Voltage should be 11-14 volts (voltage may fluctuate). If voltage is within specification, go to next step. If voltage is not within specification, possible causes are wiring harness failure, O2 sensor (G3/6) failure or defective right cylinder bank ME-SFI control module (N3/12).
  2. Current Consumption -  Turn ignition off. Connect ammeter between right cylinder bank ME-SFI control module connector 1 terminals No. 26 and 12. (socket box terminals No. 26 and 12). Turn ignition on. Ammeter should indicate 0.6-3.4 amps. If amperage is within specification, test is complete. If amperage is not within specification, possible causes are wiring harness failure, O2 sensor (G3/6) failure or defective right cylinder bank ME-SFI control module (N3/12). Repair as necessary.
Chapter Navigation
Return to Chapter: DTC P0141: O2 Sensor Heater Of Right O2 Sensor Downstream TWC (G3/6)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.