2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE

DI ENGINE 119 (description only)

DI Engine 119

DTC Description Only - No Test Available
1 - No malfunction in system
10 - Not used
11 - Reference resistor (DI) (R16/2)defective
12 - TN-signal (engine RPM output) is outside of tolerance range
13 - Not used
14 - Not used
15 - Ignition coil 1 output from DI control module (N1/3) defective or primary winding of ignition coil has open circuit
16 119 only Ignition coil 2 output from DI control module (N1/3) defective or primary winding of ignition coil has open circuit
17 - CKP sensor (L5) defective
18 119 only Magnets for CKP sensor (L5)not recognized
19 - Not used
2 - Maximum retard setting on at least one cylinder has been reached
20 - DI control module (N1/3)DTC memory defective
21 - MAP sensor in DI control module (N1/3) defective (recognized with engine running)
22 - Not used
23 - Not used
24 - Not used
25 - Not used
26 - DI control module (N1/3)data exchange malfunction
27 - LH-SFI control module (N3/1)data exchange malfunction
28 - EA/CC/ISC control module(N4/1) data exchange malfunction
29 - Not used
3 - Not used
30 - Not used
31 - Not used
32 - Not used
33 - Not used
34 - Ignition misfire cylinder1 (engine 104) cyl. 1 (engine 119)
35 - Ignition misfire cylinder5 (engine 104) cyl. 5 (engine 119)
36 - Ignition misfire cylinder3 (engine 104) cyl. 4 (engine 119)
37 - Ignition misfire cylinder6 (engine 104) cyl. 8 (engine 119)
38 - Ignition misfire cylinder2 (engine 104) cyl. 6 (engine 119)
39 - Ignition misfire cylinder4 (engine 104) cyl. 3 (engine 119)
4 - MAP sensor in DI control module (N1/3) defective
40 119 only Ignition misfire cyl. 7 (engine119)
41 119 only Ignition misfire cyl. 2 (engine119)
5 - Knock sensor 1 and/or 2 defective
6 - CMP sensor (L5/1) defective
7 - Knock control-output switch in DI control module (N1/3) defective
8 - Transmission overload protection switch (S65) does not close
9 - Transmission overload protection switch (S65) does not open
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.