Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz SL600FACTORY OEM SERVICE PROCEDURE
Performing basic programming - AR00.19-P-0200A
MODEL 129
| Adjusting | |||
| 1 | Set time on instrument cluster | ||
| 2 | Set clock of stationary heater | ||
| 3 | Normalize side power windows | ||
| 4 | Activate steering angle sensor | Adaptive damping system (ADS) with level control system (Code (216b). Adaptive damping system (ADS II) with electronic level control (Code (216c). |
AR46.10-P-0300-01A |
| 5 | Code radio | Becker 2000. |
AR82.60-P-7502-01A |
| Becker Mexico, Grand Prix, Europa, Avus. |
AR82.60-P-7502-01C |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.