2000 Mercedes Benz S430FACTORY OEM SERVICE PROCEDURE

Engine Control Unit Documentation (LI07.00-P-044871)

Publication date: 2009-01-15
Reference number: LI07.00-P-044871
Supersedes refnos: 07.00/52B, 07.00/52C

ENGINE CONTROL UNIT DOCUMENTATION

ENGINE CONTROL UNIT DOCUMENTATION

TECHNICAL SERVICE BULLETIN

Reference Number(s): LI07.00-P-044871 Version 1 (P-B-07.00/52C, February 6, 2007), Date of Issue:  January 15, 2009
Mercedes-Benz: All Passenger Models Equipped with Engines M112 / M113 (ME2.8) and Engines M137, M156, M271, M272, M273 and M275 (ME9.7)
Design Group: 07.00 General
Reason For Change:
Superceded Bulletin(s): P-B-07.00/52B, Date of Issue:  April 21, 2006

COMPLAINT

Engine control unit warranty claim debited.

CAUSE

All engine control units exchanged under warranty must be accompanied by the Control Unit Log. Claims submitted without this information will be debited back to the dealer. No other documentation will be accepted or required.

REMEDY

As of DAS version 04/05, the Control Unit Log menu item can be found from the following STAR Diagnosis menu:

  1. Control Units -> Drive -> Motor electronics -> Control unit log

In order to obtain an accurate investigation of the engine control unit, it is important to enter the customer complaint and any additional information with the "Customer complaint (Remarks concerning damage case)" screen.

Screen Shot Examples (refer to attachments)

  1. Fig 1 through Fig 4 - STAR Diagnosis Menus
  2. Fig 5 - Customer Complaint Screen
  3. Fig 6 - Completed Control Unit Log
NOTE: For M112 and M113 engines with ME 2.8 and also for M137, M156, M271, M272, M273 and M275 engines with ME 9.7 injection systems, documentation is required. For injection system identification, please refer to Figures Fig 4, Fig 5 and Fig 6 on top right corner (examples on screen shots show "Control Unit ME9.7").
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.