Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Door Control Module Failure (DTB 03/00-2; MB-NET 006)
Reference number: DTB 03/00-2; MB-NET 006
DOOR CONTROL MODULE FAILURE
TECHNICAL SERVICE BULLETIN
| MERCEDES-BENZ: | Model 220 |
| GROUP: | 72 - Doors |
SUBJECT
DEALER TECHNICAL BULLETIN 03/00
SERVICE INFORMATION
03/00-2 GROUP 72 - MODEL 220, DOOR CONTROL MODULE FAILURE: Please note that door control module connector failures on the V220 may result from excessive soap solution attacking the electrical connectors. This may occur when after market window-tinting film is applied. During this process, the glass needs to be well lubricated to squeegee out the air bubbles between the glass and the film. The lubricant can run down the glass and enter the electrical connectors. To avoid this complaint, we strongly recommend that the interior door panels and door control modules be removed and the electrical connectors be covered to prevent the lubricant from penetrating the connectors and causing corrosion and subsequent poor conductivity.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
