2000 Mercedes Benz S430FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
Alarm Siren With Auxiliary Battery At left front wheelhouse.
Audio Amplifier Right side of luggage compartment.
Battery Right side of trunk.
CTEL/GPS Roof Antenna At rear center of roof.
CTEL Interface Under right rear seat.
CTEL Transmitter-Receiver Left side of trunk.
Cylinder 1 Ignition Coil On right side of engine.
Cylinder 2 Ignition Coil On right side of engine.
Cylinder 3 Ignition Coil On right side of engine.
Cylinder 4 Ignition Coil On right side of engine.
Cylinder 5 Ignition Coil On left side of engine.
Cylinder 6 Ignition Coil On left side of engine.
Cylinder 7 Ignition Coil On left side of engine.
Cylinder 8 Ignition Coil On left side of engine.
Data Link Connector At upper left footwell.
Driver ETR Squib Bottom of left "B" pillar. See
Fanfare Horns Behind front bumper.
Generator (Engine 275) On front of engine. See Figure.
Left Front IR Receiver Unit In left front door.
Left Window Airbag Squib At left "C" pillar.
LR ETR Squib At left "C" pillar.
Passenger ETR Squib Bottom of right "B" pillar. See
Passenger Side AB Squib 1 Right side of dash.
Passenger Side AB Squib 2 Right side of dash.
Right Front Door Airbag Squib In right front door.
Right Front IR Receiver Unit In right front door.
Right Window Airbag Squib At right "C" pillar.
RR ETR Squib At right "C" pillar.
Top Rear Window Antenna Amplifier Center rear of roof.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.