Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Performing Alignment Procedure
- Drive vehicle onto electronic alignment system. Unlock rotary and sliding plates. Install brake pedal winch on brake pedal. Attach measuring headed to each wheel. Perform initial measurement. Check vehicle level at front and rear axle and adjust as necessary. See RIDING HEIGHT ADJUSTMENT . Check ball point position. See BALL POINT POSITION .
- Check and adjust rear axle toe-in. Check and adjust camber and caster on front axle. Check and adjust camber and caster on rear axle (ML320, ML430 and ML55 only). If rear axle camber (except ML320, ML430 and ML55) is not within specification, problem may be caused by too great a difference in vehicle level between left and right side of vehicle or accident damage. If vehicle was damaged in an accident, toe-in may be out of specification also. Check and adjust front axle toe-in. Remove measuring heads and brake pedal winch. Test drive vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.