Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Front Axle | |||
| Eccentric Bolt Lock Nut | |||
| C230, C280, C43, CLK320, CLK430 & SLK230 | 89 (120) | ||
| CL500 (1999), S320, S420, S500 (1999) | 133 (180) | ||
| E300 Turbo Diesel, E320, E430 & E55 (Except 4-Matic Models) | 89 (120) | ||
| E320 & E430 (4-Matic Models) | 81 (110) | ||
| Idler Arm To Bearing Bushing | |||
| C230, C280, C43, CLK320, CLK430 & SLK230 | 22 (30) | ||
| CL500 (1999), S320, S420 & S500 (1999) | 26 (35) | ||
| Tie-Rod Lock Nut | |||
| C230, C280, C43, CL500 (1999), CLK320, CLK430, S320, S430, S500 (1999) & SLK230 | 37 (50) | ||
| E300 Turbodiesel, E320, E430 & E55 | 44 (60) | ||
| Rear Axle | |||
| Cross Brace-To-Frame Floor Self-Locking Bolt | |||
| SLK230 | 44 (60) | ||
| Tie-Rod Eccentric Bolt Lock Nut | |||
| C230, C280, C43, CL500 (1999), CLK320, CLK430, E300 Turbo Diesel, E320, E430, E55, S320, S420, S500 (1999), SL500 & SLK230 | 52 (70) | ||
| Stabilizer Bar Mounting Brackets | 15 (20) | ||
| Wheel Lug Bolt Alloy Or Steel Wheel | |||
| C230, C280, C43, CLK320, CLK430, E300 Turbo Diesel, E320, E430, E55, SL500 & SLK230 | 81 (110) | ||
| CL500 (1999), S320, S420 & S500 (1999) | 111 (150) | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.