Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Windowbag, location/purpose/design/function - GF91.60-P-4014GH
Model 163 as of 1.9.0
| Window airbag position | The inflator modules with the left rear window airbag initiator (R12/22)
and right rear window airbag initiator (R12/32)
are arranged in the left and right C pillars
. When folded, the corresponding air hose is located in the side roof frame. |
||
| Window airbag - task | GF91.60-P-4014-02A | ||
| Window airbag - design | GF91.60-P-4014-03A | ||
| Window airbag - function | GF91.60-P-4014-04A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.