Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2000 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE

Section 5 (Automatic A/C-Heater Systems): Specifications

WARNING: This page is about a different car, the 2001 Mercedes-Benz SL500 and 2000 Mercedes-Benz SL500. However, it is still accessible from the selected car via links, so may be relevant.

SPECIFICATIONS

Application

Specification

Compressor Type

Nippondenso 10PA17 10-Cyl. Or Sanden TRS105

Compressor Belt Tension

⁽¹⁾

Compressor Oil Capacity ⁽²⁾

With 10PA17 Compressor

4.7 ozs.

With TRS105 Compressor

5.0 ozs.

Refrigerant (R-134a) Capacity

33.5 ozs.

System Operating Pressures

⁽³⁾

⁽¹⁾	Belt tension is automatically adjusted by belt tensioner.

⁽²⁾	Use Densooil 8 (A 001 989 08 03) with 10PA17 compressor. Check A/C underhood specification label for other compressor listed.

⁽³⁾	Information is not available from manufacturer.

Chapter Navigation

Return to Chapter: Section 5 (Automatic A/C-Heater Systems)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.