2000 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE

Section 3 (Automatic A/C-Heater Systems): Specifications

WARNING: This page is about a different car, the 2000 Mercedes-Benz C43, 2000 Mercedes-Benz C280, 1999 Mercedes-Benz C43, and 1999 Mercedes-Benz C280. However, it is still accessible from the selected car via links, so may be relevant.
SPECIFICATIONS

Application Specification
Compressor Type
C280 & C43 Nippondenso 7SB16 7-Cyl. Or 6CA17 6-Cyl.
Compressor Belt Tension (1)
Compressor Oil Capacity (2)
C280 & C43
With 7SB16 Compressor 4.0 ozs.
With 6CA17 Compressor 5.2 ozs.
Refrigerant (R-134a) Capacity
C280 & C43 30.0 ozs.
System Operating Pressures (3)
(1) Belt tension is maintained by automatic belt tensioner.
(2) Use Densoil 8 (A 001 989 08 03) with Nippondenso 7SB16 compressor. Check A/C underhood specification label for other compressor listed.
(3) Information is not available from manufacturer.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.