Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Fuel System: Diesel
NOTE:
Diesel specifications apply to 1999 model year.
DIESEL INJECTION PUMP TIMING
| Application | Degrees ATDC | |
|---|---|---|
| Testing | ||
| With Position Sensor | 13.5-14.5 | |
| With Digital Tester | 13.5-14.5 | |
| Adjusting | ||
| With Position Sensor | 15 | |
| With Digital Tester | 14-15 | |
DIESEL INJECTOR NOZZLE PRESSURE
| Application | psi (bar) | |
|---|---|---|
| Injector Opening Pressure | ||
| New Injector | 1958-2103 (135-145) | |
| Used Injector | 1885 (130) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.