Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 9: Wiper Switch
Using Harness Adapter (210 589 01 63 00), connect Breakout Box (129 589 00 21 00) to combination control module. Turn ignition switch to RUN position. Measure voltage between terminals No. 42 and 65 at breakout box with wiper switch in appropriate position. See WIPER SWITCH VOLTAGE table. If voltage is as specified, combination switch is okay at this time. If voltage is not as specified, check wiring. If wiring is okay, replace combination switch.
| Switch Position | Voltage At Breakout Box |
|---|---|
| Touch Wipe | 6.8-8.6 |
| Interval Wipe | 3.3-4.2 |
| Low Speed | 6.8-8.6 |
| High Speed | 11-14 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.