2000 Mercedes Benz E55FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Splices

SPLICES LOCATION

Component Component Location
Z3 Under trim, at left rear panel.
Z3/11 At base of center of windshield.
Z3/28 Under trim, at left rear panel.
Z3/29 Under front fuse & relay box.
Z3/31 At base of left "A" pillar.
Z7/1 At base of center of windshield.
Z7/19 Under fuse & relay box.
Z7/26 At base of right "A" pillar.
Z7/33 AT base of right "A" pillar.
Z21/10 Under right front seat.
Z21/11 Under trim, at right rear panel.
Z21/5 Under trim, at left front kick panel.
Z21/6 Under trim, at left front kick panel.
Z28/25 In thin harness, right of steering column support.
Z28/26 In harness, right of steering column support.
Z30 At base of center of windshield.
Z30/1 At base of center of windshield.
Z30/2 At base of center of windshield.
Z81 At base of center of windshield.
Z81/4 Under left rear of center console.
Z92 Under front fuse & relay box.
Z99/1 At base of right "A" pillar.
Z99/2 At base of right "A" pillar.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.