2000 Mercedes Benz E55FACTORY OEM SERVICE PROCEDURE

Pump element task/design/function - GF07.02-P-5004H

ENGINE 605.910 in MODEL 202.125 

ENGINE 605.960 in MODEL 202.128 /188 

ENGINE 605.912 in MODEL 210.010 /210 /610 

ENGINE 606.912 in MODEL 210.020 

ENGINE 606.962 in MODEL 210.025 /225 

ENGINE 606.961 in MODEL 140.135 

ENGINE 605.962 in MODEL 210.015 /215 

Design 

Fig 1: Identifying Pump Element Design
G04623816Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  Pump element task To deliver fuel  
  Pump element design The pump plunger (10/16) is provided with a vertical groove (10/19) and a helical cut in its side. This plunger helix forms a control edge (10/17) that serves to regulate the quantity of fuel for injection.
The pump barrel is provided with a bore (10/15) (feed and control bore), through which the fuel travels from the suction gallery to the pressure chamber and through which it can flow back again at the end of delivery.
 
  Pump element function   GF07.02-P-5004-01H 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.