2000 Mercedes Benz E55FACTORY OEM SERVICE PROCEDURE

Accelerator position sensor location/task/design/function - GF07.04-P-5029H

ENGINE 604.910 in MODEL 202.121 to 31.7.96 

ENGINE 605.910 in MODEL 202.125 

ENGINE 605.960 in MODEL 202.128 /188 

ENGINE 604.912 in MODEL 210.004 to 31.5.96 

ENGINE 605.912 in MODEL 210.010 /210 /610 

ENGINE 606.912 in MODEL 210.020 

ENGINE 602.982 in MODEL 210.017 /217 /617 

ENGINE 606.961 in MODEL 140.135 

ENGINE 606.962 in MODEL 210.025 /225 

ENGINE 605.962 in MODEL 210.015 /215 

Shown on model 202 to 11/94 

Fig 1: Identifying Accelerator Pedal Position Sensor - Shown On Model 202 To 11/94
G04623888Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  Accelerator pedal position sensor task
  • To detect the position of the accelerator pedal
  • To detect closed throttle position
  • To supply the corresponding signals to the IFI [ERE] control module (N3/7) or the DFI [EVE] control module (N3/8)
 
  Accelerator pedal position sensor design Comprises a variable resistor (rotary potentiometer), which is linked to the accelerator pedal via a Bowden cable, and a CTP switch  
  Accelerator pedal position sensor function   GF07.04-P-5029-01H 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.