Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mercedes Benz C43FACTORY OEM SERVICE PROCEDURE
Self-Diagnostic System
WARNING: This page is about a different car, the 1996 Mercedes-Benz C280 and 1996 Mercedes-Benz C220. However, it is still accessible from the selected car via links, so may be relevant.
Using Hand-Held Tester (HHT), retrieve and record codes from RCL control module using manufacturer's instructions. Perform appropriate system test. See DTC IDENTIFICATION CHART (RCL CONTROL MODULE) table.
DTC IDENTIFICATION CHART (RCL CONTROL MODULE)
| Code | Cause | Test/Remedy |
|---|---|---|
| B1000 | RCL Control Module | Replace RCL Control Module |
| B1100 | Control Line Deactivation | Test 13: Control Line Deactivation Short To Voltage and Test 14: Control Line Deactivation Short To Ground |
| B1101 | Control Line Deactivation | Test 15: Control Line Activation Short To Voltage and Test 16: Control Line Activation Short To Ground |
| B1102 | Drive Authorization System Control Line Circuit | TEST 21: CAN "L" Data Line Open |
| B1103 | Red Indicator Lamp Circuit | Test 5: RCL Receiver Red Indicator Light |
| B1104 | Green Indicator Lamp Circuit | Test 6: RCL Receiver Green Indicator Light |
| B1701 | Incorrect Authorization Code (4 & 6 Cylinder) | Test 6: RCL Receiver Green Indicator Light |
| B1702 | Incorrect Authorization Code (8 & 12 Cylinder) | Test 6: RCL Receiver Green Indicator Light |
| B1703 | Attempt Was Made To Start Vehicle Locked With RCL | Test 6: RCL Receiver Green Indicator Light |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
