2000 Mercedes Benz C230FACTORY OEM SERVICE PROCEDURE

Production Date Information

NOTE: This diagnostic information applies to 1997-2000 models with 2.3L engine (No. 111), equipped with Motor Electronics Sequential Fuel Injection (ME-SFI).

Some diagnostic information is divided by vehicle production date breaks. Be sure diagnostic information being used applies to vehicle being diagnosed. The following production date break is used in this diagnostic information.

  • Some information applies to C230 (model 202) with and without supercharger.
  • Some information applies to C230 (model 202) as of 8/96.
  • Some information applies to C230 (model 202) as of 9/97
  • Some information applies to C230 (model 202) up to 8/97.
  • Some information applies to C230 (model 202) up to 6/97.
  • Some information applies to SLK230 (model 170) only.
  • Some information applies to supercharger only.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.