Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Logic Section
After the ignition is switched on, system initialization and safety checking is started. The system is enabled following a satisfactory check sequence. The conditioned input signals are processed in the logic section and the following values are calculated:
- Vehicle speed from the front wheel speed signals.
- Vehicle acceleration from several successive wheel speed measurements.
- Diaphragm speed: The control module checks the voltage signal from the diaphragm travel sensor every 3 ms. The pedal speed is calculated from the voltage different between two successive measurements.
- Learning algorithm: Calculation of vehicle deceleration for adaptation of triggering threshold to different braking system conditions.
- Threshold: This is calculated from the basic threshold (vehicle identification values), vehicle speed, brake pedal speed and the values from the learning algorithm.
If the calculated values exceed the specified threshold, BAS activation is initiated.
BAS activation is interrupted immediately following a signal from the BAS release switch.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
