Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS
| Component | Component Location |
|---|---|
| W2 | Lower right front of engine compartment, behind headlight. See Figure . |
| W6 | Left rear cargo area, behind trim. See Figure . |
| W7 | Right rear cargo area, behind trim. See Figure . |
| W8 | On tailgate, behind trim. |
| W9 | Behind right headlight. See Figure . |
| W11/3 | Top center front of engine. |
| W16 | Left rear corner of engine compartment. See Figure . |
| W16/4 | Right rear of engine compartment. See Figure . |
| W18 | Under driver's seat, below carpet. See Figure . |
| W19 | Under right front seat, below carpet. See Figure . |
| W26 | Under center console, on SRS mounting bolt. See Figure . |
| W29/2 | Below passenger's side of dash, behind kick panel. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.