1999 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS

Component Component Location
Acoustimass Bass Module Under driver's seat. See Figure .
All Activity Module (AAM) In left side of engine compartment, in "E" box. See Figure .
ASR/ETS/ESP Hydraulic Unit In left side of engine compartment, below washer bottle.
ATA Control Module At right rear of engine compartment.
Engine Control Module (ME-SFI) In left side of engine compartment, in "E" box. See Figure .
ESP/SPS/BAS Control Module In left side of engine compartment, in "E" box.
ETC Control Module Behind center of dash. See Figure .
MB-Immobilizer Control Module In top right side of steering column. See Figure .
SRS Control Module Below front of center console. See Figure .
Traction System Control Module In left side of engine compartment in "E" box. See Figure .
Trailer Turn Signal Control Module Integral to trailer harness.
Transfer Case Control Module Below center console, behind shift assembly. See Figure .
Trip Computer Control Module In front of roof.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.