1999 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Connectors

CONNECTORS

Component Component Location
X11/4 (Black, 16-Pin) Below driver's side of dash.
X18 (Orange, 28-Pin) Behind left side of dash.
X18/1 (Black, 9-Pin) In tailgate, behind trim.
X18/2 (Black, 6-Pin) Left side of engine compartment, in "E" box.
X18/3 (Black, 10-Pin) Right rear of vehicle, behind rear tire.
X18/5 (Black, 3-Pin) Left rear cargo area (trim removed).
X18/6 (Black, 3-Pin) Left rear cargo area, behind trim.
X18/7 (Black, 9-Pin) Left side of engine compartment, in "E" box.
X18/10 (White, 2-Pin) Left side of engine compartment, in "E" box.
X18/11 (Black, 2-Pin) Lower left front of engine compartment, behind headlamp.
X18/12 (Red, 2-Pin) Left side of engine compartment, in "E" box.
X18/18 (Black, 10-Pin) Behind center of dash.
X18/29 (Gray, 6-Pin) Left side of engine compartment, in "E" box.
X18/30 (Black, 8-Pin) Left side of engine compartment, in "E" box.
X22 (Black, 16-Pin) Left side of engine compartment, in "E" box.
X22/2 (Black, 13-Pin) Right front of transmission, on bell housing.
X28/13 (Black, 2-Pin) Underside of left/right front seat.
X33/19 (Green, 2-Pin) Left side of engine compartment, in "E" box.
X35/1 (Black, 20-Pin) Front of left front door.
X35/2 (Black, 20-Pin) Front of right front door.
X35/3 (Black, 20-Pin) Front of left rear door.
X35/4 (Black, 20-Pin) Front of right rear door.
X36/4 (Black, 1-Pin) Left rear cargo area, behind trim.
X52 (Black, 16-Pin) Left rear cargo area, behind trim.
X54/1 (Red, 2-Pin) Underside of left/right front seat.
X54/9 (White, 2-Pin) Under left/right front seat.
X54/10 (Green, 2-Pin) Underside of left/right front seat.
X54/20 (Black, 2-Pin) Rear of left/right front seat back, behind trim.
X55/3 (Black, 16-Pin) Underside of driver's seat.
X55/4 (Black, 16-Pin) Underside of passenger's seat.
X58 (Black, 13-Pin) On rear bumper.
X58/3 (Green, 2-Pin) Behind center of dash.
X58/4 (White, 2-Pin) Right rear cargo area.
X58s1 (Green, 2-Pin) Rear of vehicle, in trailer connector.
X88/17 (Black, 2-Pin) Left side of engine compartment, in "E" box.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.