1999 Mercedes Benz CLK430FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Splices

SPLICES

Component Component Location
Z3 Center rear of engine compartment, in thick harness, 400 mm from S11, brake fluid level switch.
Z3/1 Left center dash, at base of windshield.
Z3/15 In right harness crosstray, on lower right flank of console.
Z3/26 In left engine compartment harness, at left rear of engine compartment.
Z3/27 In left engine compartment harness, at left rear of engine compartment.
Z4/4 In right component compartment.
Z6/16 Left center of dash at base of windshield.
Z7/35 Engine compartment, rear center, in engine harness.
Z10 In left interior harness, at left "B" pillar.
Z20 In left interior harness, at left "B" pillar.
Z20/1 In left trunk harness, in breakout to CTEL transmitter/receiver.
Z20/2 In left trunk harness, in breakout to CTEL transmitter/receiver.
Z20/5 In left trunk harness, in breakout to CTEL transmitter/receiver.
Z21/2 In right harness crosstray, on lower right flank of console.
Z29/1 In left interior harness, at sill panel below left front door.
Z30/3 In left interior harness, at sill panel below left front door.
Z30/4 In left interior harness, at sill panel below left front door.
Z30/5 In left interior harness, at left "B" pillar.
Z36/1 In right luggage compartment harness, behind right side of bumper.
Z36/2 In right luggage compartment harness, behind right side of bumper.
Z36/3 In left engine compartment harness, behind left side of front bumper.
Z36/4 In left engine compartment harness, behind left side of front bumper.
Z36/8 In dash harness, behind instrument cluster.
Z37/2 In right component compartment.
Z37/3 In right component compartment.
Z38 In left interior harness, at sill panel below left front door.
Z40 In left interior harness, at sill panel below left front door.
Z81 In left harness crosstray at left rear of center console.
Z81/4 In left harness crosstray, at left flank of center console.
Z87/15 Behind radio.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.