Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Dynamometer/Speedometer Test
Disconnecting Electronic Stability Program (ESP) control module is not allowed. The ME-SFI control module and Electronic Transmission Control (ETC) Module (TCM) rely on Vehicle Speed Sensor (VSS) data through the Controller Area Network (CAN) bus. To disable brake and engine regulation functions of the ESP, ASR, ETS, ABS control modules, perform one of the following procedures:
- Without Scan Tool - Turn ignition off. Connect Adapter (140 589 14 63 00) to underhood Data Link Connector (DLC). Jumper adapter sockets No. 1 and 6. Start engine. Appropriate system malfunction indicator light must illuminate. Erase DTCs after completing work.
- With Scan Tool - Turn ignition off. Disconnect front axle Vehicle Speed Sensor (VSS) connector. Start engine. Appropriate system malfunction indicator light must illuminate. Erase DTCs after completing work.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.