Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Notes Regarding Replacement Of All Activity Module
After replacement of All Activity Module (AAM)(N10), Hand Held Tester (HHT) must be used in order to version code AAM. The version coding is menu driven. See Fig 1 .
AAM transmitter keys and engine control modules are "married together", meaning that AAM and engine control module must "learn" key code of vehicle. Additionally, AAM "learns" numerous key codes of transmitter key. These assignments can not be changed later on, which means that if AAM is defective the following must be completed to repair the system:
- Order a new AAM, along with a master key, after advising of identification code from your facing PDC.
- Using HHT, reset engine control module and allow engine control module to "relearn".
Additional transmitter keys and replacement of lost transmitter keys requires a "relearning" of AAM. The relearning procedure for new transmitter keys is performed using HHT. To gain access to menu proceed as follows: Body & Accessories - AAM - Control Module Adaption - Transmitter key/Transponder. Only after relearning process is new transmitter key usable.
Prior to using transmitter key, lost old transmitter key must be deactivated. The HHT can be used to determine which keys which are currently deactivated via actual values for "drive authorization".
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
