1998 Mercedes Benz ML320FACTORY OEM SERVICE PROCEDURE

Synchronization Of Transmitter Keys

NOTE:

If transmitter battery has been replaced it may be necessary to resynchronize a transmitter key .

In order to synchronize transmitter keys, perform following steps:

  1. Insert transmitter into ignition lock.
  2. Test to see if transmitter key has been recognized as a valid (ATA status indicator lamp [E33] blinks).
  3. Remove transmitter key from ignition lock.
  4. Then within 1 minute, do the following:
    • Press and hold OPEN button and at same time press "CLOSE ALL" button (5) times.
    • Press function buttons as necessary.
    • Only after completed synchronization process is Remote Function of transmitter possible.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.