Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inline injection pump location/task/function - GF07.02-P-5001H
ENGINE 605.910 in MODEL 202.125
ENGINE 605.960 in MODEL 202.128 /188
ENGINE 605.912 in MODEL 210.010 /210 /610
ENGINE 606.912 in MODEL 210.020
ENGINE 606.962 in MODEL 210.025 /225
ENGINE 606.961 in MODEL 140.135
ENGINE 605.962 in MODEL 210.015 /215
Shown on engine 605
Task
- To generate injection pressure
- To regulate the amount of fuel for injection
Function
The fuel pump (13) delivers fuel to the suction gallery of the inline injection pump (10). On the pump plunger downstroke fuel flows from the suction gallery via the feed and control bore (10/15) into the pump barrel (10/8). Driven by the camshaft (10/7), the pump plunger (10/16) delivers the fuel via the pressure valve (16/3) and the injection line to the injector nozzle.
With its delivery stroke completed, the pump plunger (10/16) is pushed back to its starting position by the compression spring (10/13). The spring-loaded pressure valve (16/3) simultaneously shuts off fuel supply to the injection line.
The pump barrel (10/8) and the pump plunger (10/16) together constitute what is called the pump element.
| Pressure valve location/task/design/function | GF07.05-P-5001H | ||
| Pump element task/design/function | GF07.02-P-5004H | ||
| IFI [ERE] injected quantity control location/task/ design/function | GF07.12-P-3137H | ||
| IFI [ERE] inline injection pump lubrication function | GF07.12-P-3138H | ||
| IFI [ERE] electrohydraulic shut-off actuator location/task/design/function | GF07.12-P-3133H | ||
| IFI [ERE] fuel pump location/task/function | GF07.12-P-3120H | ||
| Overflow restrictor location/task/design/function | GF07.05-P-5000H | ||
| IFI [ERE] fuel quantity actuator location/task/function | GF07.12-P-3131H | ||
| Fuel rack position sensor location/task/design/function | GF07.04-P-5022H |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
