1998 Mercedes Benz CL600FACTORY OEM SERVICE PROCEDURE

Engine Performance DTCS

LH Engine 120

DTC Description Only - No Test Available
1 No malfunction in system
10 CTP (idle) recognition from EA/CC/ISC control module (N4/1), short circuit (DTC10 can be displayed even if no fault is present.)
11 AIR pump system, open/short circuit (DTC11 can be displayed even if no fault is present.)
12 Burn-off control for hotwire MAF sensor, open/short circuit
13 Left or right IAT sensor(B17/5 or B17/6), open/short circuit
14 Not used
15 Not used
16 Left or right EGR switchover valve (Y27/2 or Y27/3), open/short circuit (DTC16can be displayed even if no fault is present.)
17 No CAN data transmission with EA/CC/ISC control module (N4/1) (DTC17can be displayed even if no fault is present.)
18 No CAN data with left or right DI control module (N1/4 or N1/5)
19 No CAN data transmission between left and right LH-SFI control module
2 Left or right ECT sensor(B11/9 or B11/10) sensor circuit 1, open/short circuit
20 No CAN data transmission from left or right LH-SFI control module (N3/2 or N3/3)
21 Left or right O2S 1 (before TWC) (G3/3 or G3/4), open/short circuit
22 O2S 1 heater, open/shortcircuit
23 Left or right purge control valve (Y58/2 or Y58/3), open/short circuit
24 Not used
25 Left or right adjustable camshaft timing solenoid (Y49/1 or Y49/2), open/short circuit
26 Upshift delay switch over valve (Y3/3), open/short circuit
27 Left or right injectors (Y63or Y64), open/short circuit
28 Left or right LH-SFI control module coding, open circuit
3 Left or right ECT sensor(B11/9 or B11/10) sensor circuit 2, open/short circuit
4 Voltage at left or right hot wire MAF sensor (B2/3 or B2/4) insufficient or too high, or open circuit in ground wire at hot wire MAF sensor (DTC4 can be displayed even if no fault is present.)
5 Not used
6 Not used
7 TN-signal (RPM signal) incorrect or open/short circuit
8 Left or right CMP sensor(L5/2 or L5/3) signal, open/short circuit
9 Starter signal (circuit 50) missing, open/short circuit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.