1997 Mercedes Benz SL320FACTORY OEM SERVICE PROCEDURE

Test Preparation

Ensure battery voltage is 11-14 volts. Ensure all fuses are okay. Ensure central locking system is operating properly. Ensure transmitter batteries are okay. Open sun roof and lower windows approximately 4" (100 mm). Unlock vehicle using interior central locking switch. Remove key from ignition switch. Close all doors and trunk lid.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.