Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Mercedes Benz SL320FACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code (DTC HFM-SFI)
- Turn ignition off. Perform pretest conditions. See PRETEST CONDITIONS under SELF-DIAGNOSTIC SYSTEM. Turn ignition on. Press push-button, located on diagnostic connector in right rear corner of engine compartment, for 2-4 seconds. See Fig 1 .
- HFM-SFI control unit will begin output of fault codes by flashing LED light on diagnostic connector. See Fig 1 . If LED only flashes once, this indicates no fault codes are stored. If fault codes are stored, LED will flash indicating stored fault code.
- Press push-button again for 2-4 seconds. If more fault codes are stored, LED on diagnostic connector will display next code. Continue pressing push-button for 2-4 seconds at a time until LED lights steadily indicating end of fault code display. Record all fault codes. See HFM-SFI FAULT CODE IDENTIFICATION table to identify fault code.
HFM-SFI FAULT CODE IDENTIFICATION
| Fault Code | Malfunctioning Component/System | ||||
|---|---|---|---|---|---|
| 1 | (1) | ||||
| 2 | Oxygen Sensor | ||||
| 3 | Lambda (Air/Fuel Mixture) Control | ||||
| 4 | Secondary Air Injection | ||||
| 5 | EGR System | ||||
| 6 | Idle Speed Control (ISC) | ||||
| 7 | Ignition System Defect | ||||
| 8 | Engine Coolant Temperature Sensor | ||||
| 9 | Intake Air Temperature | ||||
| 10 | Hot-Film Mass Airflow Sensor | ||||
| 11 | Engine Speed (TN) Signal | ||||
| 12 | Oxygen Sensor Heating | ||||
| 13 | (2) | ||||
| 14 | (2) | ||||
| 15 | Wide Open Throttle (WOT) Function | ||||
| 16 | Closed Throttle Position (CTP) Function | ||||
| 17 | Data Transfer | ||||
| 18 | Camshaft Adjustment Solenoid | ||||
| 19 | Fuel Injectors Or Self-Adaptation Of Emission System At Limit | ||||
| 20 | Vehicle Speed Signal | ||||
| 21 | Purge Switchover Valve | ||||
| 22 | Camshaft Position Sensor | ||||
| 23 | Intake Manifold Absolute Pressure (Engine Running) | ||||
| 24 | Flexplate Segments (Crankshaft Position Sensor) | ||||
| 25 | Knock Sensors | ||||
| 26 | Upshift Delay Switchover Valve | ||||
| 27 | (2) | ||||
| 28 | Engine Coolant Temperature Change Monitor | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
