Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code Memory (Section 11)
Diagnostic module (OBD II< N59/1) uses 2 different plug connectors for DTC readout:
In case of DTC P0131 and P0133, the exact cause of the fault in oxygen sensor 1 (O2S 1) can be read via MODE 5 with the generic scan tool. To do so, the following codes must be entered in the generic scan tool:
- DTC P0131
Code JD 4A HEX - DTC P0133
Code JD 7E HEX
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.