Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1995 Mercedes Benz SL320FACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS IN DEGREES

Application

Preferred

Range

Basic Version

With Adaptive Damping System

Camber

Front

- 0.83

- 1.17 To - 0.67

Caster

Front

10.45

9.95 To 10.95

Toe-In

Front

0.33

0.17 To 0.50

Rear

0.42

0.33 To 0.58

Toe-Out On Turns

Inner

⁽¹⁾

Outer

⁽¹⁾

Without Adaptive Damping System

Camber

Front

- 0.58

- 0.68 To - 0.41

Caster

Front

10.25

9.75 To 10.75

Toe-In

Front

0.33

0.17 To 0.50

Rear

0.42

0.33 To 0.58

Toe-Out On Turns

Inner

⁽¹⁾

Outer

⁽¹⁾

⁽¹⁾	Information is not available.

WHEEL ALIGNMENT SPECIFICATIONS

Application	Preferred: In. (mm)	Range: In. (mm)
Toe-In
Front	0.16 (4.0)	0.08 To 0.25 (2.0 To 6.3)
Rear	0.21 (5.3)	0.17 To 0.29 (4.3 To 7.3)

Chapter Navigation

Return to Chapter: Wheel Alignment Specifications & Procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.