1995 Mercedes Benz SL320FACTORY OEM SERVICE PROCEDURE

Electrical System Tests Component Locations (Section 21)

ELECTRICAL SYSTEM TESTS COMPONENT LOCATIONS (SECTION 21)

Component See
Base Module (N16/1) - Model 129 Fig 1
CHECK ENGINE MIL (A1e26)
Model 129 Fig 1
Model 202 Fig 2
Data Link Connector - DTC Readout (X11/4)
Model 129 Fig 1
Model 202 Fig 2
Diagnostic Module - OBD II (N59/1)
Model 129 Fig 1
Model 202 Fig 2
Diagnostic Module - OBD II Generic Scan Tool Connector (X11/22)
Model 129 Fig 1
Model 202 Fig 2
DM Pressure Sensor - HFM-SFI (B5/2)
Model 129 Fig 1
Model 202 Fig 2
Engine Control Module - HFM-SFI (N3/4)
Model 129 Fig 1
Model 202 Fig 2
O2S 2 - After the TWC (G3/1)
Model 129 Fig 1
Model 202 Fig 2
Overvoltage Protection Relay Module - 9 Pole (K1/2) - Model 202 Fig 2
Purge Control Valve (Y58/1)
Model 129 Fig 1
Model 202 Fig 2
Purge Flow Switchover Valve (Y27/6)
Model 129 Fig 1
Model 202 Fig 2
Fig 1: Diagnostic Module Component Locations - Section 21 (Model 129)
G00197109Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.