1994 Mercedes Benz SL320FACTORY OEM SERVICE PROCEDURE

System Tests: Notes

CAUTION: To avoid damaging control modules all electrical testing should be done with a DVOM. DO NOT use an analog meter or test light to check control module circuits.

After verifying problem using COMPLAINT RELATED DIAGNOSTIC CHART (SECTION 12)Β  under TROUBLE SHOOTING or DIAGNOSTIC TROUBLE CODE MEMORY (SECTION 11)Β , perform appropriate test step(s). For aid in using diagnostic charts, see USING DIAGNOSTIC CHARTSΒ .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.