1991 Mercedes Benz 560SECFACTORY OEM SERVICE PROCEDURE

Air Injection

  1. With engine off and at operating temperature, disconnect coolant temperature sensor connector. Install 2500-ohm test resistor between connector terminals No. 2 and 4, this step is to simulate 68Β°F (20Β°C) to CIS-E control unit. Disconnect vacuum line from side connection of switchover valve and connect vacuum tester in line using "Y" fitting.
  2. Start engine. Disconnect air suction hose at air pump filter and close off with finger. Air pump should be running and vacuum should be about 20 in. Hg. If suction is felt at end of hose, go to next step. If no suction is felt, go to step 4).
  3. The air pump must disengage after about one minute and the vacuum will drop to zero. If this does not happen, unplug air injection relay. If vacuum now drops, replace air injection relay. If vacuum still does not drop, check routing of vacuum lines and switchover valve. Repair or replace components as necessary.
  4. Unplug air injection relay. Check voltage between terminals No. 1 and 3 at plug connector. Voltage should be about 12 volts. If voltage is not about 12 volts, check power supply and ground wiring. Check air shutoff valve function and air hoses for proper routing.
  5. Check voltage between terminal No. 1 and terminal No. 2 at plug connector. Voltage should be 12 volts. If voltage is incorrect, check power supply. If voltage is correct, replace air injection relay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.