Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Mercedes Benz 560SECFACTORY OEM SERVICE PROCEDURE
Lower Chamber (Differential) Pressure Test
- Connect Meter Adapter Cable (102 589 04 63 00) between differential pressure regulator and ammeter. Disconnect O2 sensor lead at connector located under right front floor mat. Turn ignition on. Meter reading for lower chamber pressure should be constant 7-9 mA. If reading is incorrect, check lambda control.NOTE: During warm-up and at operating temperature, current to differential pressure regulator is determined by coolant temperature sensor, O2 sensor and ECU.
- Bridge fuel pump relay socket, terminals Nos. 7 and 8 with jumper wire. Lower chamber pressure should be about 5.8 psi (.4 kg/cm2 ) less than system pressure reading determined earlier. Unplug coolant temperature sensor.
- Note lower chamber pressure and differential pressure regulator current. If coolant temperature sensor plug is disconnected, temperature sensor resistance should be zero ohms, differential pressure regulator current should be about 114-132 mA, and lower chamber pressure should be about 15.95-18.85 psi (1.1-1.3 kg/cm2 ) less than system pressure. Reconnect coolant temperature sensor.
- Check pressure and current values at coolant temperature of 68°F (20°C). Sensor resistance should be 2200-2800 ohms. Differential pressure regulator current 9-14 mA and lower chamber pressure should be about 5.8 psi (.4 kg/cm2 ) less than system pressure.
- Check pressure and current values at coolant temperature of 176°F (80°C). Sensor resistance should be 290-370 ohms, differential pressure regulator current 7-9 mA and lower chamber pressure should be about 5.8 psi (.4 kg/cm2 ) less than system pressure.
- Check pressure and current values at coolant temperature of 212°F (100°C). Sensor resistance should be 140-220 ohms, differential pressure regulator current 7-9 mA and lower chamber pressure should be about 5.8 psi (.4 kg/cm2 ) less than system pressure.
- If not to specification, check coolant temperature sensor for malfunction. Coolant temperature sensor should also be checked if there are warm-up problems with vehicle. Test lambda control. If lower chamber pressure is too high, check orifice in fuel distributor for restriction. Install fuel pump relay. Reconnect O2 sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
