Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clearing Codes
Disconnecting battery will not erase codes. Each code stored in EDS control unit must be erased individually. After impulse counter readout codes are displayed, repeat sequence to display malfunction code. When code displays, wait 2 seconds and then press START button for at least 6-10 seconds. LED will blink once and/or impulse counter readout will display "=1", indicating code is erased. Continue this sequence until all codes are erased. Disconnect test equipment.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.