Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Mercedes Benz 560SLFACTORY OEM SERVICE PROCEDURE
Code 2, Throttle Valve Switch
- Turn ignition "OFF". Unplug CIS-E control unit connector. Connect ohmmeter lead between sockets No. 2 and No. 5 of socket box. See Fig 1 . With throttle at wide open position, ohmmeter should read less than 1 ohm resistance. If not, check wire harness.
- Unplug throttle valve switch connector. With ohmmeter leads between sockets No. 5 and No. 3 of socket box, ohmmeter reading should be less than one ohm. With ohmmeter leads between ground and socket No. 2, ohmmeter reading should be less than one ohm. If not, repair open circuit.
- With ohmmeter leads between pins No. 2 and 3 of throttle switch connector, ohmmeter should read infinite resistance. With throttle valve at wide open position, ohmmeter should read less than one ohm. Adjust or replace throttle valve switch if reading is out of range.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
