Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Description & Operation
Air injection system works to reduce exhaust emissions and improve driveability. Control unit engages and disengages air pump through an air injection relay, located in relay box next to brake master cylinder. SeeFig 1 .
Air injection occurs for a maximum of 60 seconds while coolant temperatures above 63Β°F (17Β°C), engine below 2500 RPM, full load contact not engaged and/or lambda control operating.
Under these conditions, control unit energizes electro-magnetic clutch of the air pump by air injection relay. Simultaneously, same relay energizes switchover valve which in turn provides vacuum to air injection shutoff valve. Air pump draws air from air filter and delivers to exhaust ports in cylinder head. See Fig 2 .
Air injected from air pump promotes oxidation of CO and HC in the catalyst. Heat created by oxidation brings catalyst to operating condition quicker.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
