1987 Mercedes Benz 300SDLFACTORY OEM SERVICE PROCEDURE

Engine Performance: System: Turbocharger: Operation

Exhaust gases leaving the cylinders flow through exhaust manifold directly into turbocharger turbine housing. Force of gases turns turbine wheel, which in turn spins compressor wheel at same speed. Turbine and compressor wheel speeds can reach up to 100,000 RPM. See Fig 1 and Fig 2 .

Fig 1: Airflow Pattern of Garrett Turbocharger
G34705Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fresh air drawn in by compressor wheel is compressed and delivered to combustion chamber. When engine is idling, the engine operates like a normal aspirated engine.

With increased speeds and higher RPM, exhaust gases are expelled with increasing velocity. This causes turbine wheel to turn faster, increasing boost pressure at compressor wheel.

Boost pressure is routed to intake manifold and to individual cylinders, completing the cycle. The aneroid compensator on top of fuel injection pump automatically adjusts fuel quantity injected into cylinders depending upon boost pressure, or atmospheric pressure in intake manifold. Correct air-fuel relationship is maintained at all times.

Fig 2: Cutaway View of Wastegate Valve
G34707Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Should wastegate fail, a pressure switch installed in intake manifold closes an electrical circuit, energizing a switch-over valve. This valve closes pressure line to intake manifold and simultaneously opens aneroid compensator to atmosphere. This reduces fuel quantity being injected.

Pressure switch only functions when intake manifold boost pressure reaches 16 psi (1.1 kg/cm2 ). When pressure drops below this figure, pressure switch opens electrical circuit and venting of pressure line is stopped.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.