Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Mercedes Benz 300DFACTORY OEM SERVICE PROCEDURE
Altitude Correction Capsule
- Turn engine off. Steering should be in lock "2" position. Disconnect connector from altitude correction capsule. Connect multimeter and set to volt scale.
- Probe and check voltage between terminals No. 1 and 2 of correction capsule connector. Voltage reading should be 5 volts. If voltage is 5 volts, replace altitude correction capsule. If voltage is not 5 volts, repair open circuit. If no open circuit is found, replace EDS control unit. See Fig 1 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.