Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Mercedes Benz 560SLFACTORY OEM SERVICE PROCEDURE
Fuel Injection System - BOSCH Cis-E
- Description
- Operation
- On-Board Diagnostic Readout System
- Fuel Pump Relay
- Cold Start Valve Activation
- Fuel Enrichment
- Maximum Rpm Limitation
- Fuel Pump
- Diaphragm Pressure Regulator
- Fuel Distributor Unit
- Coolant Temperature Sensor
- Electronic Control Unit (Ecu)
- Idle Speed Control Unit
- Idle Speed Air Valve
- Voltage Protection Relay (VPR)
- Oxygen Sensor
- Lambda Control
- Logic Circuit
- Fixed Operating Mode
- EZL Ignition Operation
- Diagnostic Testing - 420 & 560 Series
- Component Testing - 420 & 560 Series
- Component Testing - 190 & 300 Series
- Airflow Sensor Plate
- Cold Start System
- Fuel Delivery & System Pressures
- Electrical Components
- Fuel Pump Relay
- Coolant Temperature Sensor
- Acceleration Enrichment
- After-Start Enrichment
- Deceleration Shut-Off
- Full-Load Enrichment
- Overvoltage Protection
- Altitude Correction
- Lambda Control
- Oxygen Sensor
- Oxygen Sensor Heater
- Electronic Idle Speed Control
- Idle Speed Stabilization (Automatic Transmission Engaged)
- Idle Speed Stabilization (A/C Compressor Engaged)
- Throttle Valve Switch
- Trouble Shooting - 420 & 560 Series
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
