1986 Mercedes Benz 560SLFACTORY OEM SERVICE PROCEDURE

Test Oxygen Sensor

NOTE: If oxygen sensor signal is not present, the oxygen sensor malfunction indicator on the instrument panel will light up.
  1. Disconnect oxygen sensor plug and connect male part of plug to ground. Start engine. Test sensor voltage between female part of plug and ground. Sensor voltage should be around 450 mV. If not okay, replace oxygen sensor. If okay, go to step 2).
  2. Stop engine. Check wire from oxygen sensor plug to CIS-E control unit (terminal No. 8) for continuity. Resistance should be about zero ohms. If not okay, repair interruption. If okay, test is complete.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.