Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Mercedes Benz 560SECFACTORY OEM SERVICE PROCEDURE
Vacuum Amplifier
- Connect Vacuum Tester (116 589 25 21 00) with "Y" fitting to connection "A" and read vacuum value at idle speed. For manual transmissions, it should be about 9 in. Hg. For automatic transmissions, it should be about 10 in. Hg.
- If vacuum is above or below specified value, adjust vacuum. To adjust vacuum, pull off dust cap from vacuum amplifier and turn adjusting screw with a 4 mm socket wrench until specified value is obtained. If vacuum value is not okay, go to step 3).
- Check supply vacuum at connection. Replace vacuum amplifier if necessary. Check vacuum lines.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.