1985 Mercedes Benz 300CDFACTORY OEM SERVICE PROCEDURE

Vacuum Control Unit: Installation

  1. Install new gasket and steel ring. Make sure tang on vacuum control unit engages in main rack. Install last 3 mounting screws removed.
  2. Insert punch in lower right-hand screw bore. Check main rack position with mark on punch. When punch touches main rack, press lightly on punch and move control lever on injection pump from "stop" position to "full load" stop. Punch must follow the main rack smoothly. If correct, install remaining screw.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.